Configuring Dchp Server - Zte ZXR10 5900 Series User Manual

Step Command
1
ip dhcp enable
ZXR10(config)#
2
no ip dhcp enable
ZXR10(config)#
Command
ZXR10(config-if-vlanX)#
proxy]

Configuring DCHP Server

1. To enable DHCP or stop DHCP, use the following command.
2. To enable DHCP working mode on the interface, use the fol-
lowing command.
ip dhcp mode [server | relay |
After enabling built-in DHCP Relay process, system processes
IP address request sent from DHCP client on the interface and
allocate IP address for DHCP Client dynamically by external
DHCP Server configured in the interface.
After enabling built-in DHCP Proxy process, system will process
IP address request sent from DHCP client on the interface,
allocate IP address for DHCP Client dynamically by external
DHCP Server configured in the interface and replace the long
lease with short lease to client. When DHCP Client sending
continue-to-rent request, if the long lease allocated by DHCP
Server is not timeout, DHCP Proxy will response DHCP Client
directly and won't send continue-to-rent request to external
DHCP Server to relieve the burden of external DHCP Server.
Only one function among system built-in DHCP Server function,
DHCP Relay function and DHCP Proxy function can be run on
the same interface.
3. To bind policy to an interface or delete configuration, use the
following commands.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 9 DHCP Configuration
Function
After enabling DHCP, system
will take DHCP ip address
request on the interface which
is configured user interface
attribute. This system builts
in DHCP Server function and
DHCP Relay function which
are enabled by using this
command.
By default, disable DHCP.
This stops DHCP.
Function
Relay: enalbe DHCP Relay on
the interface;
server: enable DHCP Server on
the interface;
proxy:enable DHCP Proxy on
the interface.
89