ZXR10 5900/5200 Series User Manual (Basic Configuration Volume)
Step Command
1
ZXR10(config)#
<interfacename>
2
ZXR10(config)#
ets <interfacename>
3
clear protocol-protect {packets-count |
ZXR10#
buckets-count}<interfacename>
176
Confidential and Proprietary Information of ZTE CORPORATION
Note:
The discard of some protocol packets will make the correspond-
ing service invalid.
Configuration Example
1. This example shows how to configure port arp protocol and set
alarm threshold as 2500.
Zxr10#conf t
Zxr10(config)#inter gei_1/1
Zxr10(config-gei_1/1)# protocol-protect mode arp enable
Zxr10(config-gei_1/1)# protocol-protocol alarm mode arp 2500
2. This example shows how to configure icmp protocol packet
passing peak/average speed.
Zxr10#conf t
Zxr10(config)#inter gei_1/1
Zxr10(config-gei_1/1)# protocol-protect peak-rate mode icmp 500
Zxr10(config-gei_1/1)# protocol-protocol average-mode mode icmp 250
Maintenance and Diagnosis
ZXR10 5900/5200 provides show command to help maintenance
and diagnosis. Common commands used in control-plane-security
maintenance and diagnosis are as follows.
show protocol-protect packet-config
show protocol-protect token-buck
Function
This views a certain port
type and the protocol packet
configuration and receiving
statistics on this port.
This views protocol packet
receiving speed configuration
and statistics on a certain
port.
This clears protocol statistic
count on a certain port.