ZXR10 5900/5200 Series User Manual (Basic Configuration Volume)
Command
ntp enable
ZXR10(config)#
Command
ntp source <ip-address>
ZXR10(config)#
Command
clock timezone
ZXR10(config)#
Command
ZXR10(config-router)#
112
Confidential and Proprietary Information of ZTE CORPORATION
2. To enable NTP function, use the following command.
3. To configure the source address used by the NTP in the process
of sending a synchronization time request, use the following
command.
4. To configure time zone of the switch, use the following com-
mand.
5. To view the NTP running state, use the following command.
show ntp status
NTP Configuration Example
This example shows routing switch as a NTP client and assume
that the NTP protocol version is 2. This is shown in
F
28 NTP CONFIGURATION EXAMPLE
IGURE
Function
This enables NTP function.
Function
This configures the source
address used by the NTP
in the process of sending a
synchronization time request.
Function
This configures time zone of the
switch.
Function
This views the NTP running
state.
Figure
28.