Establishing Cluster - Zte ZXR10 5900 Series User Manual

Command
ztp start
ZXR10(config)#
Command
ztp timer
ZXR10(config)#
Command
group switch-type { candidate |
ZXR10(config)#
independent | (commander [ (ip-pool <ip_addr>( {
mask <ip_addr>| length <mask_len>}] ) }
Command
group name <name >
ZXR10(config)#
Command
group handtime <time>
ZXR10(config)#
Command
group holdtime <time>
ZXR10(config)#
7. To set ZTP timing topology collection time, use the following
command.

Establishing Cluster

1. To set the switch to command, candidate or independent
switch, use the following command.
2. To change the cluster name, use the following command.
3. To set the cluster handshake time, use the following command.
4. To set the holding time between the member and command
switch on the command switch, use the following command.
5. To add a specific equipment or MAC address as a member on
the command switch, use the following command.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 13 Cluster Management Configuration
Function
This conducts once topology
collection.
Function
This sets ZTP timing topology
collection time.
Function
This sets the switch to
command, candidate or
independent switch and
allocates an IP address pool to
cluster.
Function
This changes the cluster name.
Function
This sets the cluster handshake
time.
Function
This sets the holding time
between the member and
command switch on the
command switch.
147