Dhcp Relay Configuration Example - Zte ZXR10 5900 Series User Manual

ZXR10 5900/5200 Series User Manual (Basic Configuration Volume)
F 22 DHCP SERVER CONFIGURATION
IGURE
R1 configuration:
ZXR10(config)#interface vlan 10
ZXR10(config-if-vlan10)#ip dhcp mode server
ZXR10(config-if-vlan10)#ip address 10.10.1.1 255.255.255.0
ZXR10(config-if-vlan10)#exit
ZXR10(config)#ip pool pool1
ZXR10(config-ip-pool)#range 10.10.1.10 10.10.1.100 255.255.255.0
ZXR10(config-ip-pool)#exit
ZXR10(config)#ip dhcp pool dhcp1
ZXR10(config-dhcp-pool)#ip-pool pool1
ZXR10(config-dhcp-pool)#exit
ZXR10(config)#ip dhcp policy p1 1
ZXR10(config-dhcp-policy)#dhcp-pool dhcp1
ZXR10(config-dhcp-policy)#default-route 10.10.1.1
ZXR10(config-dhcp-policy)#exit
ZXR10(config)#interface vlan 10
ZXR10(config-if-vlan10)#ip dhcp policy p1
ZXR10(config)#ip dhcp enable

DHCP Relay Configuration Example

Router at the user end is connected directly as DHCP relay when
the DHCP client and server are not in the same network.
R1 enables DHCP relay function and a single server 10.10.2.2 pro-
vides DHCP server function. This mode is usually adopted when a
lot of hosts require the DHCP service. This is shown in Figure 23.
100 Confidential and Proprietary Information of ZTE CORPORATION