Final Gear Related Parts Inspection - Suzuki kq750 Service Manual

3B-30 Differential:
• Install the final driven gear (8) and shim(s) (9) into the
final gear case.
• Install the shim(s) (10).
• Install the O-ring to the final gear cover (11).
• Apply a small quantity of grease to the O-ring.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
11
• Apply a small quantity of thread lock to the final gear
cover tools and tighten them to the specified torque
diagonally.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
Final gear cover bolt (M8) (c): 26 N·m (2.6 kgf-m,
19.0 lb-ft)
Final gear cover bolt (M10) (d): 55 N·m (5.5 kgf-
m, 40.0 lb-ft)
(d)
8
9
I831G1320124-01
10
I831G1320125-01
(c)
(c)
I831G1320126-01
• Check the backlash and tooth contact. Refer to "Final
Gear Shim Inspection and Selection (Page 3B-31)".
• Install the rear brake assembly. Refer to "Rear Brake
Assembly Removal and Installation in Section 4C
(Page 4C-2)".

Final Gear Related Parts Inspection

Refer to "Final Gear Assembly Removal and Installation
(Page 3B-23)".
Final Driven Gear Oil Seal
Inspect the oil seals lip for damage or wear. If any defect
are found, replace the oil seals with new ones.
Final Driven / Drive Gear Bering
Inspect the bearings for abnormal noise and smooth
rotation. Replace the bearings if there is anything
unusual.
B831G23206018
I831G1320127-01
I831G1320128-01
I831G1320129-01