Fuel Level Gauge Inspection; Speedometer Inspection; Speed Sensor Removal And Installation - Suzuki kq750 Service Manual

Fuel Level Gauge Inspection

Inspect the fuel level gauge in the following procedures:
1) Remove the fuel pump. Refer to "Fuel Pump
Assembly Removal and Installation in Section 1G
(Page 1G-9)".
2) Measure the resistance at each fuel level gauge in
float position. If the resistance is incorrect, replace
fuel pump with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Resistance (Ω)
Float position
Full "a"
Empty "b"
"a": 27.7 mm (1.09 in)
3) Install the fuel pump. Refer to "Fuel Pump Assembly
Removal and Installation in Section 1G (Page 1G-
9)".

Speedometer Inspection

If the speedometer, odometer or trip meter does not
function properly, inspect the speed sensor and the
coupler connections. If the speed sensor and coupler
connections are OK, replace the combination meter unit
with a new one. Refer to "Combination Meter Removal
and Installation (Page 9C-3)".
B831G29306008
Resistance
6.4 – 8.4 Ω
216 – 222 Ω
" a "
" b "
I831G1930014-01
"b": 166 mm (6.54 in)
B831G29306009
Combination Meter / Fuel Meter / Horn:

Speed Sensor Removal and Installation

Removal
1) Remove the engine side cover. Refer to "Rear Side
Exterior Parts Removal and Installation in Section
9D (Page 9D-9)".
2) Disconnect the speed sensor coupler (1).
3) Remove the speed sensor (2).
Installation
Install the speed sensor in the reverse order of removal.
Pay attention to the following points:
• Apply grease to the speed sensor O-ring.
: Grease 99000–25160 (Water resistance
grease)
• Tighten the speed sensor mounting bolt to the
specified torque.
Tightening torque
Speed sensor mounting bolt (a): 10 N·m (1.0 kgf-
m, 7.0 lb-ft)
(a)
9C-6
B831G29306010
1
2
I831G1930015-01
I831G1930016-02
I831G1930017-03