Rear Stabilizer Removal And Installation - Suzuki kq750 Service Manual

2) Apply grease to the lip of the inner dust seals, spacer
(1) and inside of dust seals (2).
: Grease 99000–25160 (Water resistance
grease or equivalent)
3) Install the spacers (1), dust seals (2) and washers
(3) to the rear suspension knuckle.
1
3
2
2

Rear Stabilizer Removal and Installation

Removal
1) Remove the rear wheels. Refer to "Front / Rear
Wheel Removal and Installation in Section 2D
(Page 2D-2)".
CAUTION
!
Make sure that the vehicle is supported
securely.
2) Disconnect the stabilizer joints (1) from the rear
suspension lower arm and stabilizer bar.
1
3) Remove the stabilizer plates (2) and bushings (3).
2
3
3 2
3
1
3
I831G1230050-01
B931G22306015
1
I831G1230055-01
2
3
I831G1230052-02
4) Remove the stabilizer bar (4).
Installation
Install the stabilizer in the reverse order of removal. Pay
attention to the following points:
Applicable model
Up to 5SAAR41A197105886
Install the stabilizer in the reverse order of removal.
Pay attention to the following points:
• Apply grease to the inside of stabilizer bushing.
: Grease 99000–25100 (SUZUKI SILICONE
GREASE or equivalent)
Applicable model
From 5SAAR41A197105887
Install the stabilizer in the reverse order of removal.
Pay attention to the following points:
• Do not apply grease to the inside of stabilizer bushing.
Rear Suspension: 2C-14
4
I831G1230053-01
I831G1230051-03
I931G1230002-02