Rear Suspension Inspection; Rear Shock Absorber Inspection; Spring Pre-Load Adjustment; Rear Wheel Hub / Suspension Knuckle Removal And Installation - Suzuki kq750 Service Manual

Rear Suspension Inspection

Refer to "Suspensions Inspection in Section 0B
(Page 0B-22)".

Rear Shock Absorber Inspection

Inspect the rear shock absorber in the following
procedures:
1) Remove the rear shock absorber. Refer to "Rear
Shock Absorber Removal and Installation (Page 2C-
3)".
2) Inspect the rear shock absorber for damage and oil
leakage, and absorber bushing for wear or damage.
If any defects are found, replace the rear shock
absorber with a new one.
CAUTION
!
Do not attempt to disassemble the rear shock
absorber. It is unserviceable.
3) Install the rear shock absorber. Refer to "Rear Shock
Absorber Removal and Installation (Page 2C-3)".

Spring Pre-load Adjustment

B931G22306004
WARNING
!
Be sure to adjust the spring pre-load on the
both suspensions equally.
B931G22306005
After installing the rear suspension, adjust the spring
pre-load as follows:
• Turn the spring tension ring (1) to the desired position.
NOTE
Position 1 provides the softest spring tension
and position 5 provides the stiffest.
STD Position
2nd position
Rear Wheel Hub / Suspension Knuckle Removal
and Installation
I831G1230006-01
NOTE
The right and left suspension parts are
installed procedure for one side is the same
as that for the other side.
Removal
1) Remove the cotter pin (1) and loosen the hub nut (2).
Rear Suspension:
1
2
1
2
1
2C-4
B931G22306006
3
4
5
I831G1230063-01
B931G22306007
I831G1230007-01