3) First, check for insulation with the tester between
terminals "A" and "B". Next, check for continuity
between "A" and "B" with 12 V voltage applied,
positive (+) to terminal "C" and negative (–) to
terminal "D". If continuity does not exist, replace the
relay with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test (
"A"
"B"
Fuel Hose Inspection
Refer to "Fuel Line Inspection in Section 0B (Page 0B-
10)".
Fuel Feed Hose Removal and Installation
Removal
1) Remove the rear fender. Refer to "Rear Side Exterior
Parts Removal and Installation in Section 9D
(Page 9D-9)".
2) Disconnect the fuel feed hose (1).
Installation
1) Install the fuel feed hose as shown in the fuel hose
routing diagram. Refer to "Fuel Hose Routing
Diagram (Page 1G-3)".
2) Install the rear fender. Refer to "Rear Side Exterior
Parts Removal and Installation in Section 9D
(Page 9D-9)".
)
"C"
"D"
I718H1170013-01
B831G21706005
B831G21706006
1
I831G1170014-01
Fuel Level Gauge Inspection
Refer to "Fuel Level Gauge Inspection in Section 9C
(Page 9C-6)".
Fuel Level Indicator Inspection
Refer to "Fuel Level Indicator Inspection in Section 9C
(Page 9C-5)".
Fuel Tank Removal and Installation
Removal
WARNING
!
• Keep away from fire or spark.
• Spilled gasoline should be wiped off
immediately.
• Work in a well-ventilated area.
1) Remove the rear fender. Refer to "Rear Side Exterior
Parts Removal and Installation in Section 9D
(Page 9D-9)".
2) Remove the fuel tank outer cover. Refer to "Rear
Side Exterior Parts Removal and Installation in
Section 9D (Page 9D-9)".
3) Place a rag under the fuel feed hose and disconnect
the fuel feed hose (1) from the fuel pump.
4) Disconnect the fuel tank coupler (2) and fuel tank
breather hose (3).
2
5) Remove the fuel tank mounting bolts.
6) Remove the fuel tank from the left side.
Fuel System:
1G-8
B831G21706007
B831G21706008
B831G21706009
3
1
I831G1170015-01
I831G1170016-01