Repair Instructions; Brake Pedal Height Inspection And Adjustment; Front Brake Light Switch Inspection; Rear Brake Light Switch Inspection - Suzuki kq750 Service Manual

Brake Pedal Height Inspection and Adjustment

Refer to "Rear Brake Pedal / Rear Brake (Parking Brake)
Lever Inspection and Adjustment in Section 0B
(Page 0B-19)".

Front Brake Light Switch Inspection

Inspect the front brake light switch in the following
procedures:
1) Disconnect the front brake light switch coupler (1).
1
2) Inspect the switch for continuity with a tester.
If any abnormality is found, replace the front brake
light switch with a new one. Refer to "Front Brake
Master Cylinder / Brake Lever Disassembly and
Assembly (Page 4A-11)".
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Color
Terminal (B)
Position
ON
OFF
3) Connect the front brake light switch coupler.

Repair Instructions

Rear Brake Light Switch Inspection

B831G24106001
Inspect the rear brake light switch in the following
procedures:
1) Remove the left front inner fender. Refer to "Front
B831G24106002
2) Disconnect the rear brake light switch lead wire
3) Inspect the switch for continuity with a tester.
I831G1410002-01
Position
Terminal (B)
4) Connect the rear brake light switch lead wire coupler
I831G1410003-02

Rear Brake Switch Inspection and Adjustment

Check the rear brake light switch so that the brake light
will come on just before pressure is felt when the brake
pedal is depressed. If the brake light switch adjustment
is necessary, turn the adjuster nut (1) in or out while
holding the brake pedal.
Brake Control System and Diagnosis:
Side Exterior Parts Removal and Installation in
Section 9D (Page 9D-6)".
coupler (1).
If any abnormality is found, replace the rear brake
light switch with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Color
Terminal (O)
ON
OFF
(1).
4A-4
B831G24106003
1
I831G1410034-01
Terminal (W/B)
I831G1410032-03
B831G24106004
1
I831G1410005-01