Rear Brake Pedal Removal and Installation
Removal
1) Remove the right inner fender. Refer to "Front Side
Exterior Parts Removal and Installation in Section
9D (Page 9D-6)".
2) Remove the right mud guard. Refer to "Rear Side
Exterior Parts Removal and Installation in Section
9D (Page 9D-9)".
3) Remove the spring (1) and (2).
4) Disconnect the rear brake cable (3). Refer to "Rear
Brake Cable Removal and Installation (Page 4A-8)".
3
5) Remove the nut (4), washer (5) and bolt (6).
4
6) Remove the rear brake pedal.
Installation
Install the rear brake pedal in the reverse order of
removal. Pay attention to the following points:
• Apply grease to the O-rings as shown in the rear
brake pedal construction. Refer to "Rear Brake Pedal
Construction (Page 4A-13)".
CAUTION
!
Replace the O-rings with new ones.
: Grease 99000–25160 (Water resistance
grease)
B831G24106018
1
2
I831G1410039-02
5
6
I831G1410040-02
Brake Control System and Diagnosis:
• Apply grease to the pivot part of brake pedal.
: Grease 99000–25160 (Water resistance
grease)
• Apply thread lock to the bolt (1) and tighten to the
specified torque.
: Thread lock cement 99000–32050
(THREAD LOCK CEMENT 1342 or equivalent)
Tightening torque
Rear brake pedal pivot nut (a): 11 N·m (1.1 kgf-m,
8.0 lb-ft)
• After installed rear brake cable, adjust the adjuster
nut. Refer to "Rear Brake Pedal / Rear Brake (Parking
Brake) Lever Inspection and Adjustment in Section 0B
(Page 0B-19)".
• Install the removed parts.
4A-14
I831G1410041-01
1
(a)
I831G1410042-02