Conrod And Crankshaft Inspection - Suzuki kq750 Service Manual

1D-59 Engine Mechanical:
• Tighten the starter cup nut to the specified torque by
holding starter cup with the suitable bar (2).
Tightening torque
Starter cup nut (a): 38 N·m (3.8 kgf-m, 27.5 lb-ft)
(a)
Water Pump
• Apply grease to the O-ring.
CAUTION
!
Replace the O-ring with a new one.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Tighten the water pump mounting bolts (1) to the
specified torque.
Tightening torque
Water pump mounting bolt: 10 N·m (1.0 kgf-m, 7.0
lb-ft)
1
(a)
Starter Motor
Install the starter motor. Refer to "Starter Motor Removal
and Installation in Section 1I (Page 1I-4)".
Engine Top Side
Assemble the engine top side. Refer to "Engine Top Side
Assembly (Page 1D-21)".

Conrod and Crankshaft Inspection

Refer to "Engine Bottom Side Disassembly (Page 1D-
45)".
Conrod Small End I.D.
Measure the conrod small end inside diameter with the
dial calipers.
If conrod small end inside diameter exceeds the service
I831G1140289-01
limit, replace the conrod.
Special tool
34 mm))
Conrod small end I.D.
Service limit: 23.040 mm (0.9071 in)
I831G1140290-01
1
(a)
I831G1140291-02
(A): 09900–20605 (Dial calipers (1/100 mm, 10 –
B831G21406035
(A)
I831G1140292-02