Iap Sensor Removal And Installation; Tp Sensor Inspection; Tp Sensor Removal And Installation - Suzuki kq750 Service Manual

1C-2 Engine Electrical Devices:

IAP Sensor Removal and Installation

Removal
1) Remove the left inner fender. Refer to "Front Side
Exterior Parts Removal and Installation in Section
9D (Page 9D-6)".
2) Disconnect the IAP sensor coupler (1) and vacuum
hose (2).
3) Remove the IAP sensor (3).
1
Installation
Install the IAP sensor in the reverse order of removal.

TP Sensor Inspection

Refer to "DTC "C14" (P0120-H/L): TP Sensor Circuit
Malfunction in Section 1A (Page 1A-34)".

TP Sensor Removal and Installation

Removal
NOTE
Prior to disassembly, mark sensor original
position with a paint or scribe for accurate
reinstallation.
1) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-5)".
2) Disconnect the TP sensor coupler (1) and remove
the TP sensor (2).
B831G21306005
3
2
I831G1130003-01
B831G21306006
B831G21306007
2
1
I831G1130004-01
Installation
NOTE
When replacing the TP sensor, turn the
ignition switch ON and OFF.
Install the TP sensor in the reverse order of removal.
Pay attention to the following points:
• Apply a thin coat of engine oil to the O-ring.
• Install the TP sensor (1) and tighten the TP sensor
mounting screw to the specified torque.
NOTE
• Align the throttle shaft end "A" with the
groove "B" of TP sensor.
• Apply grease to the throttle shaft end "A" if
necessary.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
Tightening torque
TP sensor mounting screw: 2 N·m (0.2 kgf-m, 1.5
lb-ft)
"A"
1
"B"
NOTE
Make sure the TP valve open or close
smoothly. If the TP sensor adjustment is
necessary, refer to "TP Sensor Adjustment
(Page 1C-3)".
I831G1130005-01
I831G1130006-01