Rear Suspension Knuckle Bushing Removal And Installation - Suzuki kq750 Service Manual

2C-13 Rear Suspension:
2) Apply grease to the lip of inner dust seals, spacer (3)
and inside of dust seals (4).
: Grease 99000–25160 (Water resistance
grease or equivalent)
3) Install the spacer (3), dust seals (4) and washers (5)
to the rear suspension lower arm.
4
5
Rear Suspension Knuckle Bushing Removal
and Installation
Refer to "Rear Wheel Hub / Suspension Knuckle
Removal and Installation (Page 2C-4)".
Removal
1) Remove the following parts from the suspension
knuckle.
• Dust seal (1)
• Washer (2)
• Spacer (3)
2
3
2
1
3
4
I831G1230046-02
B931G22306014
1
2
3
2
I831G1230047-01
2) Remove the suspension knuckle bushings along
with inner dust seals with the special tools.
Special tool
(A): 09923–73210 (Bearing remover)
(B): 09930–30104 (Rotor remover sliding
shaft)
(B)
Installation
1) Install the suspension knuckle bushing and inner
dust seal with the special tool and suitable socket
wrench.
NOTE
Position the bushing s and dust seals by
referring to "Rear Suspension Assembly
Construction (Page 2C-2)".
CAUTION
!
The removed bushings and dust seals must
be replaced with new ones.
Special tool
(A): 09941–34513 (Steering race installer)
(A)
I831G1230048-03
(A)
I831G1230049-01