Compression Pressure Check; Oil Pressure Check; Sds Check; Automatic Clutch Inspection - Suzuki kq750 Service Manual

Table of Contents

Advertisement

0B-26 Maintenance and Lubrication:

Compression Pressure Check

Refer to "Compression Pressure Check in Section 1D
(Page 1D-2)".

Oil Pressure Check

Refer to "Oil Pressure Check in Section 1E (Page 1E-
2)".

SDS Check

Refer to "SDS Check in Section 1A (Page 1A-15)".

Automatic Clutch Inspection

This vehicle is equipped with a centrifugal type
automatic clutch.
To insure proper performance and longevity of the clutch
assemblies it is essential that the clutches engage
smoothly and gradually. Before checking the initial
engagement and clutch lock-up two inspection checks
must be performed to thoroughly check the operation of
the drive train.
Initial Engagement Inspection
1) Warm up the engine.
2) Connect the tachometer or the multi circuit tester
onto the spark plug high-tension cord (1).
1
3) Start the engine.
B931G20206026
4) Shift the range lever to the "High" position.
5) Slowly open the throttle and note the engine speed
(r/min) when the vehicle begins to move forward.
Special tool
B931G20206027
cell type))
Engagement speed
B931G20206028
1 500 – 2 000 r/min
6) Disconnect the tachometer and install the frame front
cover.
B931G20206029
Clutch "Lock-up" Inspection
Perform this inspection to determine if the clutch is
engaging fully and not slipping.
1) Warn up the engine.
2) Connect a tachometer onto the spark plug high-
tension code.
3) Start the engine.
4) Shift the range lever to the "High" position.
5) Apply the front and rear brakes as firm as possible.
6) Fully open the throttle fully and note the maximum
engine speed sustained during the test cycle.
CAUTION
!
Do not apply full power for more than 5
seconds or damage to the clutch or engine
may occur.
Lock-up r/min
3 500 – 4 000 r/min
If the lock-up speed (r/min) does not coincide with
the standard range, inspect the following items for
any abnormalities.
Refer to "V-belt Type Continuously Variable
I831G1020086-01
Automatic Transmission Removal and Installation in
Section 5A (Page 5A-5)".
• Clutch shoe
• Clutch wheel
• Movable drive and driven face
: 09900–26006 (Engine tachometer (solar
: 09900–25008 (Multi-circuit tester set)

Advertisement

Table of Contents
loading

Table of Contents