Suzuki kq750 Service Manual page 400

3C-4 Transfer:
9) Remove the drive shaft (9) with a plastic mallet by
installing a suitable washer with the drive face bolt.
9
10) Remove the drive bevel gear (10). Refer to "Rear
Output Shaft Removal and Installation in Section 3D
(Page 3D-6)".
11) Remove the output shaft (11) with a plastic mallet.
I831G1330011-02
10
I831G1330012-02
11
I831G1330013-01
CAUTION
!
• Do not disassemble the transfer output
shaft.
• The transfer output driven gear and
transfer output shaft is available only as an
assembly.
Installation
Install the transfer in the reverse order of removal. Pay
attention to the following points:
CAUTION
!
Apply engine oil to each gears and shafts.
• Install the bevel gear. Refer to "Rear Output Shaft
Removal and Installation in Section 3D (Page 3D-6)".
• Install the drive shaft (1) with the plastic mallet.
I831G1330014-01
1
I831G1330015-01