3D-20 Propeller Shafts:
8) Install the universal joint (4) to the yoke (5) and
bearings (6) with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
6
4
6
9) Install the circlips.
10) Install the yoke (5).
11) Install the bearings (6) by tapping with the special
tool.
Special tool
(A): 09913–70210 (Bearing installer set)
(A)
5
I831G1340074-03
I831G1340075-01
6
5
(A)
6
I831G1340076-04
12) Install the circlips to the universal joint.
13) Install the O-ring (7) to the rear propeller shaft.
14) Install the rear propeller shaft boot (8) and tighten
the clamp screw to the specified torque.
Tightening torque
Rear propeller shaft boot clamp screw (b): 2
N·m (0.2 kgf-m, 1.5 lb-ft)
8
I831G1340077-02
7
I831G1340078-02
(b)
I831G1340079-03