Front Brake Caliper Parts Inspection - Suzuki kq750 Service Manual

• Apply silicon grease to the two pins.
: Grease 99000–25100 (SUZUKI SILICONE
GREASE or equivalent)
• Install the brake caliper holder (3) to the brake caliper
(4).
4
• Install the brake pads. Refer to "Front Brake Pad
Replacement (Page 4B-2)".
• Install the brake caliper and brake hose. Refer to
"Front Brake Caliper Removal and Installation
(Page 4B-3)" and "Front Brake Hose Routing Diagram
in Section 4A (Page 4A-1)"
• Tighten the union bolt to the specified torque.
CAUTION
!
Replace the gaskets (5) with new ones.
Tightening torque
Front brake hose union bolt (a): 23 N·m (2.3 kgf-
m, 16.5 lb-ft)
5
3
I831G1420019-01
(a)
I831G1420022-01

Front Brake Caliper Parts Inspection

Refer to "Front Brake Caliper Disassembly and
Assembly (Page 4B-4)".
Brake Caliper Cylinder
Inspect the brake caliper cylinder wall for nicks,
scratches or other damage. If any damage is found,
replace the caliper with a new one.
Brake Caliper Piston
Inspect the brake caliper piston surface for any
scratches or other damage. If any damage is found,
replace the piston with a new one.
Boots
Inspect the boots for damage or wear. If any defects are
found, replace them with new ones.
Front Brakes: 4B-6
B831G24206006
I831G1420025-01
I831G1420021-01
I831G1420020-03