6C-1 Power Assisted Steering System; Precautions For Eps (Lt-A750Xp/Zk9); P/S System Note (Lt-A750Xp/Zk9); Precautions In Diagnosing Troubles - Suzuki kq750 Service Manual

Table of Contents

6C-1 Power Assisted Steering System:

Power Assisted Steering System

Refer to "General Precautions in Section 00 in related manual" and "Precautions for EPS (LT-A750XP/ZK9) in Section

00 (Page 00-1)".

When repairing EPS system, remove the front fender. Refer to "Front Side Exterior Parts Removal and

Installation in Section 9D in related manual".

Never remove the torque sensor to prevent accident and damage.

EPS body assembly fasteners are important attaching parts in that they could affect the performance

of vital parts and systems, and/or could result in major repair expense. Do not use a replacement part

of lesser quality or substitute design. Torque values must be used as specified during reassembly to

assure proper retention of these parts.

Precautions in Diagnosing Troubles (LT-A750XP/ZK9)

• Take a note of DTC indicated on the SDS tool or EPS indicator light.

• Before inspection, be sure to read "Precautions for Electrical Circuit Service in Section 00 in related manual" and

"Precautions for EPS (LT-A750XP/ZK9) in Section 00 (Page 00-1)" and understand what is written there.

• DTC C1122 (engine speed signal failure) is indicated when ignition switch is at ON position and engine is not

running, but it means there is nothing abnormal if indication changes to a normal one when engine is started.

• As DTC is stored in memory of the EPS control unit, be sure to clear memory after repair by performing the

procedure described in "DTC (Diagnostic Trouble Code) Deleting (LT-A750XP/ZK9) (Page 6C-21)".

B931G46300001

B931G46300002

B931G46300003

Table of Contents