Spring Pre-Load Adjustment; Front Wheel Hub / Steering Knuckle Removal And Installation - Suzuki kq750 Service Manual

Spring Pre-load Adjustment

WARNING
!
Be sure to adjust the spring pre-load on the
both suspensions equally.
• Turn the spring tension ring (1) to the desired position.
NOTE
Position 1 provides the softest spring tension
and position 5 provides the stiffest.
STD position
2nd position
1
• Install the removed parts.
Front Wheel Hub / Steering Knuckle Removal
and Installation
Removal
1) Remove the cotter pin (1) and loosen the hub nut (2).
2
2) Remove the front wheel assembly. Refer to "Front /
Rear Wheel Removal and Installation in Section 2D
(Page 2D-2)".
CAUTION
!
Make sure that the vehicle is supported
securely.
B831G22206006
1
2
3
4
5
I831G1220058-01
B831G22206007
1
I831G1220006-01
3) Remove the front drive shaft cover (3).
4) Remove the brake caliper. Refer to "Front Brake
Caliper Removal and Installation in Section 4B
(Page 4B-3)".
5) Remove the front wheel hub (4) by removing hub nut
(5) and washer (6).
4
6) Remove the front disc cover (7).
7
7) Remove the cotter pin, tie-rod end nut and washer.
Front Suspension: 2B-4
3
I831G1220007-01
5
6
I831G1220008-01
I831G1220010-01
I831G1220011-03