Suzuki kq750 Service Manual page 695

6C-49 Power Assisted Steering System:
4) Disconnect the torque sensor coupler (1).
5) Remove the clamp (2) and release the EPS motor
lead wire (3).
2
6) Release the clip part "A" of the EPS control unit plate
with the special tool.
Special tool
(A): 09942–83110 (Clip remover)
"A"
1
I931G3630042-01
3
I931G3630043-01
(A)
I931G3630044-01
7) Remove the fastener (4) and bolt (5).
8) Remove the EPS control unit (6) along with the EPS
control unit plate (7).
5
4
9) Remove the EPS control unit (6) from the EPS
control unit plate (7) as shown in the EPS control unit
construction. Refer to "EPS Control Unit
Construction (LT-A750XP/ZK9) (Page 6C-48)".
Installation
Install the EPS control unit in the reverse order of
removal. Pay attention to the following points:
• Tighten the EPS control unit mounting nut (1) to the
specified torque.
Tightening torque
EPS control unit mounting nut (a): 12 N·m (1.2
kgf-m, 8.5 lbf-ft)
1
(a)
• Connect the torque sensor lead wire (2).
6
7
I931G3630045-01
I931G3630046-01
2
I931G3630047-01