Battery Removal And Installation; Battery Visual Inspection; Specifications; Service Data - Suzuki kq750 Service Manual

1J-12 Charging System:

Battery Removal and Installation

Removal
1) Remove the seat. Refer to "Seat Removal and
Installation in Section 9D (Page 9D-11)".
2) Remove the battery stay (1).
3) Disconnect the battery (–) lead wire (2).
4) Disconnect the battery (+) lead wire (3).
NOTE
Be sure to disconnect the battery (–) lead
wire (2) first, then disconnect the battery (+)
lead wire (3).

Service Data

Battery
CAUTION
!
Never use anything except the specified battery.
Item
Type designation
Capacity
Generator
Item
Generator coil resistance
Generator maximum output
Generator no-load voltage
(When engine is cold)
Regulated voltage
B831G21A06008
1
I831G11A0028-02

Specifications

12 V, 64.8 kC (18 Ah)/10 HR
Approx. 400 W at 5 000 r/min
75 V (AC) and more at 5 000 r/min
13.5 – 15.5 V at 5 000 r/min
5) Remove the battery (4).
3
2
Installation
Install the battery in the reverse order of removal.
Pay attention to following point:
CAUTION
!
Never use anything except the specified
battery.
• Tighten the battery lead wire mounting bolts securely.

Battery Visual Inspection

Inspect the battery in the following procedures:
1) Remove the seat. Refer to "Seat Removal and
Installation in Section 9D (Page 9D-11)".
2) Visually inspect the surface of the battery container.
If any signs of cracking or electrolyte leakage from
the sides of the battery have occurred, replace the
battery with a new one.
If the battery terminals are found to be coated with
rust or an acidic white powdery substance, clean the
battery terminals with sandpaper.
3) Install the seat.
Specification
YTX20CH-BS
Specification
0.4 – 1.0 Ω
4
I831G11A0029-02
B831G21A06009
B831G21A07001
Note
Note