Table of Contents
Advertisement
FRONT DIFFERENTIAL GEAR OIL
Place the vehicle on a level ground.
Check the front differential gear oil levels as follows.
Remove the oil level bolt.
If the oil level is below the level hole, add the gear oil
through the filler hole until the oil flows out from the
level hole.
Reinstall the oil level bolt and the oil filler plug tighten
them securely.
NOTE:
Use hypoid gear oil SAE 90, API grade GL-5.
If the vehicle is ridden where the ambient tem-
perature is below 0°C or 32°F, use the hypoid
gear oil SAE 80, API grade GL-5.
A: Oil filler plug
B: Oil level bolt
FINAL GEAR OIL
Place the vehicle on a level ground.
Check the final gear oil levels as follows.
Remove the oil filler plug.
If the oil level does not reach the bottom of the filler
hole, add the gear oil through the filler hole until the oil
level reaches the bottom of the oil filler hole.
Reinstall the oil filler plug and tighten it securely.
NOTE:
Use Mobil Fluid 424 or an equivalent.
A: Oil filler plug
ENGINE OIL
This vehicle is shipped from factory with the
engine filled with engine oil.
Be sure to check oil level.
Remove the fasteners to take off the footrest guard lid.
NOTE:
To remove the fastener, push in the center pin
and pull out the fastener.
Be careful not to drop the fastener.
A: Footrest guard lid
B: Fastener
25
Advertisement
Table of Contents
