Rear Brake Disassembly And Assembly - Suzuki kq750 Service Manual

• Install the return spring (3) and lining indicator (4).
NOTE
Align the boss of lining indicator (4) with
wide spline on the brake cam shaft.
3
• Install the rear brake cam lever (5) to the rear brake
cam shaft.
NOTE
When installing the brake cam lever, align the
punched mark "D" with "E".
• Tighten the cam lever nut (6) to the specified torque.
Tightening torque
Rear brake cam lever nut (b): 11 N·m (1.1 kgf-m,
8.0 lb-ft)
• Install the final gear assembly to the vehicle. Refer to
"Final Gear Assembly Removal and Installation in
Section 3B (Page 3B-23)".
4
I831G1430008-01
5
"E"
"D"
6
(b)
I831G1430009-02

Rear Brake Disassembly and Assembly

Refer to "Rear Brake Assembly Removal and Installation
(Page 4C-2)".
Disassembly
1) Remove the gasket (1) and dowel pins (2).
2
2) Remove the rear brake steel plates (3) along with
the friction plates (4).
3) Remove the rear brake pressure plate (5) and balls.
Rear Brakes: 4C-3
B831G24306005
2
1
I831G1430010-02
3
4
I831G1430011-01
5
I831G1430012-01