Rear Drive Shaft Components; Rear Drive Shaft Assembly Removal And Installation - Suzuki kq750 Service Manual

Rear Drive Shaft Components

1
1. Circlip
2. Snap ring
3. Stopper ring
4. Inner boot band (Large)
Rear Drive Shaft Assembly Removal and
Installation
Removal
1) Drain the rear final gear oil. Refer to "Final Gear Oil
Inspection in Section 0B (Page 0B-14)".
2) Remove the rear wheel. Refer to "Front / Rear
Wheel Removal and Installation in Section 2D
(Page 2D-2)".
3) Remove the rear wheel hub and rear suspension
arm. Refer to "Rear Wheel Hub / Suspension
Knuckle Removal and Installation in Section 2C
(Page 2C-4)".
2
3
4
5
6
5. Inner boot
6. Inner boot band (Small)
7. Drive shaft
8. Outer boot band (Small)
B831G23106006
Drive Chain / Drive Train / Drive Shaft:
7
8
9
10
9. Outer boot
10. Outer boot band (Large)
: Apply grease.
: Do not reuse.
4) Hold the in board joint (1) of the rear drive shaft and
tug the drive shaft horizontally.
NOTE
If it is difficult to remove the rear drive shaft
from the rear differential gear case, using the
suitable tool.
3A-6
B831G23106005
I831G1310002-05
1
I831G1310020-04