NOTE: After you place the paper on the tractors, introduce a slight
amount of side-to-side tension into the paper. Set the right
tractor far enough to the right so that there are no wrinkles,
looseness, etc. in the paper. Do not set the right tractor too
far to the right, however, as too much tension may cause
the paper holes to tear away from the tractor pins.
8. Tension the paper by moving the right tractor slightly outward
and lock the right tractor with the tractor lock.
9. If you are reloading paper following a "FAN-FOLD PAPER
EMPTY" message with the printer power on, press ONLINE to
place the printer online. The printer automatically sets the
physical top of form at the leading edge of the paper and
resumes printing.
Loading Cut Sheet Paper
Upper and lower paper input cassettes are also provided if your
printer is equipped with the cut sheet paper feed option. When
printing on cut sheet paper, you can select either of two paper
output trays: the face down tray (default) or the face up tray.
To change the paper output tray selection, see the Cut Sheet
Output option on the Paper Control menu, page 100.
NOTE: If the printer runs out of paper during printing, you need not
turn off the printer to replace paper. If you leave the power
on when you replace the paper and place the printer online,
it will resume printing automatically where it left off.
Loading Cut Sheet Paper
33