Legend:
1)
Foam Gasket
2)
Screw (4)
3)
Filter Holding Plate
4)
Lamp Filter (Air Filter)
5)
Lamp Duct
12. Remove the two screws that secure the filter holding plate to
the lamp duct filter unit, then remove the lamp filter.
13. Vacuum the lamp filter, then install it.
14. Vacuum any paper dust from the printer frame.
15. Installing the fuser, making sure that the guide pins in the screw
bracket align with the holes in the side frame of the printer.
Cleaning The Cut Sheet Option Rollers
NOTE: This procedure only applies to printers with the cut sheet
option installed.
1. Turn the power switch OFF.
2. Remove the upper and lower paper cassettes from the printer.
Cleaning The Cut Sheet Option Rollers
1
2
3
4
5
109