Changing The Unit Id; Unit Ids And How They Affect System Extension Numbers - Talkswitch 48-CA User Manual

2.5.3

Changing the Unit ID

If you need to change the Unit ID of any TalkSwitch system, you can first press
from a Local Extension to enter command mode, enter a password if necessary, then
dial 0 0 . The system will respond with the Unit ID of that particular TalkSwitch.
#
To change the Unit ID, use any of the following commands once in command mode:
Unit ID
2.5.4

Unit IDs and how they affect system extension numbers

When more than one TalkSwitch is connected to a LAN and they operate in networked
mode, the extensions and voicemail have different numbers based on the Unit ID
assigned to the TalkSwitch unit they belong to.
The extensions and voice mailboxes affected by the new numbering system are listed
in the following table.
Local Extensions
Remote Extensions
Local Mailboxes
Remote Mailboxes
General Mailboxes
None of the Extension Ring Groups are affected, since they are global to the entire
system. It doesn't matter if there is one or four TalkSwitch units on a LAN, there will
always be 10 Extension Ring Groups with the extension numbers 300-309.
1 6
1
2
3
4
Unit ID 1 Unit ID 2
111-118 121-128
211-218 221-228
111-118 121-128
211-218 221-228
410-419 420-429
Touch Tone Command
01 #
02 #
03 #
04 #
Unit ID 3 Unit ID 4
131-138 141-148
231-238 241-248
131-138 141-148
231-238 241-248
430-439 440-449
T a l k S w i t c h U s e r G u i d e
#