Changing The Unit Id; How Unit Ids Affect System Extension Numbers - Talkswitch 24-CA User Manual

To resolve the conflict, assign a different Unit ID each of the units. Pick up a
telephone handset connected to one of the extension jacks on the TalkSwitch
unit you want to assign a different Unit ID to. You immediately hear a system
prompt indicating that there is a conflict and a new Unit ID needs to be
chosen. Select an available Unit ID between 2 and 4.
The system indicates that the update was successful and the front panel
lights stop flashing after several seconds. When none of the front panel 'Line'
lights are flashing, all the units are ready for network use.
Note: No IP information is required to configure TalkSwitch since it does
not use the TCP/IP protocol for voice traffic over the LAN.
IP configuration is required for remote management or VoIP once the
system has been configured.

1.5.3 Changing the Unit ID

To change the Unit ID, the configuration software must be closed!
#
Press from a Local Extension to enter command mode.
Enter a password if necessary and dial 0 0
The system responds with the Unit ID of that particular TalkSwitch. In
command mode, use any of the following commands:
Unit ID Touch Tone Command
1
#
01
2
#
02
3
#
03
4
#
04

1.5.4 How unit IDs affect system extension numbers

When more than one TalkSwitch is connected to a LAN in networked mode,
the extensions and voicemail have different numbers based on the Unit ID
assigned to the TalkSwitch unit they belong to.
1 0
#
T A L K S S W I T C H US E R G UI D E • N O R T H A M E R I C A
.