Important Notices - Talkswitch 48-CA User Manual

Important Notices

FCC and IC Warnings
This equipment complies with ACTA TIA/EIA/IS-968A and Part 68 of the Federal
Communications Commission (FCC) rules in the United States. It also complies with
regulations RSS210 and CS-03 of Industry Canada and Science Canada. This equipment
also complies with Part 15 of the FCC Rules, as well as ICES003 of Industry Canada.
Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation of the device.
FCC Part 15:
NOTE: This equipment has been tested and found to comply with the limits for a
"CLASS B" Digital Device pursuant to Part 15 of the FCC rules. These limits are designed
to provide a reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy,
and if not installed and used in accordance with these instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit different to that which the receiver
is connected.
•
Consult the dealer or an experienced Radio/TV technician for help.
This CLASS B Digital apparatus meets all requirements of the Canadian interference-
causing equipment regulations.
Changes or modifications not expressly approved by TalkSwitch could void the user's
authority to operate the equipment.
ACTA TIA/EIA/IS-968A, FCC Part 68 and IC CS-03:
Notice: The Industry Canada label identifies certified equipment. This certification
means that the equipment meets telecommunications network protective, operational
and safety requirements as prescribed in the appropriate Terminal Equipment Technical
Requirements document(s). The Department does not guarantee that the equipment
will operate to the user's satisfaction.
1 3 0 T a l k S w i t c h U s e r G u i d e