Talkswitch 48-CA User Manual page 16

Jacks/Ports What to plug in
LAN PORT You can connect to an Ethernet hub using a Category 5 cable with
RJ-45 connectors. This will support configuration across the LAN
and Internet and support VoIP calls. If you have 2, 3 or more
TalkSwitch units, you can 'network' them and they will function as
a single system. There are 3 LEDs next to the LAN port. The top
LED is on when the ethernet link is synchronized with a switch or
hub. The middle LED is on when data is being received and the
bottom LED is on when data is being transmitted.
E1 — E8 Plug in any analog device that uses a standard (RJ-11) telephone
jack, such as telephones, fax machines, internal or external PC
modems, etc. TalkSwitch identifies the extensions as 1x1 to 1x8.
(x represents the unit ID number assigned to that TalkSwitch unit).
By default, all TalkSwitch units are shipped with a unit ID of 1.
This means the extensions are 111 to 118. A TalkSwitch with
unit ID 2 would have extensions 121 to 128. For details on
setting up 2 or more units on a LAN to operate as 'networked'
units, please see section 2.5.
L1/L2, L2, L3/L4, This is where you plug in your RJ-11 telephone lines. If you
L4 have 2 lines out of 1 phone jack, you can plug into the 1/2 and
3/4 jacks. Use a surge protector if you live in an area prone to
lightning strikes.
USB Use the USB port if your PC supports USB connectivity. If you
use the USB port, you can't use the serial port simultaneously.
SERIAL Attach a serial cable (RS232) to connect TalkSwitch to your PC.
MEMORY SLOT Located on side of box: used to expand internal memory for
Voicemail and Auto Attendant messages. TalkSwitch Memory
cards can be purchased from your local TalkSwitch reseller or
from www.talkswitch.com. Simply place the memory card in the
slot and TalkSwitch will automatically detect and start using
the extra memory within 20 seconds.
POWER Plug the supplied AC Power Adapter in here. Rating: 16VAC 1.5
A output. Do not use any other power adapter, as this may
cause damage.
The 'PF' box in between E4 and L1/L2 represents power failure support. In the event of a
power failure or loss of power to TalkSwitch, Extension 114 will be able to receive calls
and make calls on Line 1.
1 0 T a l k S w i t c h U s e r G u i d e