Front panel
Ê If applicable, remove the front VGA board with the front VGA connector as
described in section
13.2.1.3 Installing the front panel module
Ê If applicable, install the front VGA board with the front VGA connector as
described in section
Figure 198: Connecting cables to the front panel module
Ê Connect the front panel cable (1).
I
If the front panel cable was secured with a cable tie, secure the front
panel cable with the cable tie.
Ê Push the front USB connector in the corresponding recess and fasten the
front USB cable with two screws (2).
Ê If applicable, connect the front VGA cable to the front VGA board and secure
it with the cable tie (3).
278
"Removing the front VGA board" on page
"Installing the front VGA board" on page
Upgrade and Maintenance Manual
283.
281.
RX2530 M1