Installation; Pairing The Camera And Monitor; Installing The Camera - Abus 56829 9 User Manual

5. Installation

5.1 Pairing the camera and monitor

To connect a camera with the monitor, proceed as follows:
1. Connect the power supply to the cameras and monitor.
2. In the TFT monitor's menu "Camera Setup -> Pairing" select the camera you require (1–4) and
confirm your choice with OK. The systems starts a 60 second countdown.
3. During the 60 seconds, press the PAIRING button on the camera cable until the green LINK LED on
the front of the camera starts to flash.
4. Bei erfolgreicher Verbindung leuchtet die LINK-LED der Kamera dauerhaft.
Warning:
Please note that connection can take up to 60 seconds.

5.2 Installing the camera

Select a suitable place for installing the camera using the camera mount. Mark the drill holes on the base
and pre-drill them. Insert the wall plugs provided and attach the mount with the screws.
Warning:
Before you start with the installation, make sure that the wireless transmission range reaches
your desired installation location.
You now have the option of swivelling the mount by 90° to position it where you want it. Loosen the screw
at the side and set the angle of view required. Then tighten the screw in the required position to fasten.
30
English