Info Module - Abus SECVEST 868 Installation Instructions Manual

After selecting Edit Ext Siren, you see the following graphic display:
Use the control buttons
by pressing the control button
input, press the control button
If you want the siren to be activated when the partition triggers a local
or external alarm, it must be set to Yes.
In the same way, train further external radio sirens and configure them
accordingly.
IMPORTANT: To train a siren connected via the Wireless Accessory
Module (WAM), read the section "Wireless Accessory
Module". This section only describes training sirens that
need no Wireless Accessory Module to control them.
to select a partition. Change the setting
under the word Change. To end
under the word Done.

10.5.2 Info module

10.5.2.1 Teach Info module
If you confirm Info Module with Select, you see the following graphic
display:
Use the control buttons
Confirm your selection by pressing the control button
word Select. To cancel input, press the control button
word Back. If you confirm your selection, you see the following graphic
display:
Switch the info module(s) to learn mode. See the product instructions
for advice on this. After switching the info module(s) to learn mode,
activate the sending of radio information by the panel by pressing the
under the word Teach. To cancel input, press the
control button
control button under the word Back.
32
to select the option Teach Info Module.
under the
under the