Removing A Pcie Adapter - IBM 9006-22P Servicing

Removing a PCIe adapter from the 9006-22P system
To remove a PCIe adapter from the system, complete the steps in this procedure.
Before you begin
Power off the system and place it in the service position. For instructions, see "Preparing the 5104-22C,
9006-22C, or 9006-22P system to remove and replace internal parts" on page 115.
Procedure
1. Attach the electrostatic discharge (ESD) wrist strap.
The ESD wrist strap must be connected to an unpainted metal surface until the service procedure is
completed, and if applicable, until the service access cover is replaced.
Attention:
• Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack,
or to an unpainted metal surface of your hardware to prevent the electrostatic discharge from
damaging your hardware.
• When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap
is used for static control. It does not increase or decrease your risk of receiving electric shock
when using or working on electrical equipment.
• If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging
and installing or replacing hardware, touch an unpainted metal surface of the system for a
minimum of 5 seconds. If at any point in this service process you move away from the system,
it is important to again discharge yourself by touching an unpainted metal surface for at least
5 seconds before you continue with the service process.
2. An adapter can share a PCIe riser card with other adapters. Label and remove any cables and plugs
that extend out of the adapters.
See Figure 43 on page 50.
Figure 43. 9006-22P PCIe adapter positions
Position
1 (UIO Slot2),
2 (UIO Slot1)
4 (WIO-R Slot)
3 (WIO Slot1),
5 (WIO Slot2),
6 (WIO Slot3)
3. For an adapter in position 1 or 2, remove the PCIe riser as shown in Figure 44 on page 51.
50 Power Systems: Servicing the 9006-22P
Step
"3" on page 50
"4" on page 53
"5" on page 54