7002-xxx
Flatbed scan assembly removal
Illustrations represent models X644e/X646e. Unless there is an indication, the procedure is the same. Differences
are shown side by side.
1.
Remove the ADF assembly. See
2.
Remove the printer left side cover. See
3.
Remove the scanner left side cover. See
4.
Remove the seven screws (A) from the SCC and HDD shield.
5.
Loosen the screws for the printer outer shield and slide shield to the left to allow enough room to remove
the scanner control card shield and the hard disk shield.
4-38
Service Manual
"ADF complete assembly removal" on page
"Printer left side cover removal" on page
"Scanner left side cover removal" on page
4-15.
4-56.
4-10.