Lexmark X642e Service Manual page 85

User attendance messages (continued)
Sub
Code Primary message
code
Load [src] with
[size]
Load [src] with
[type] [size]
Reattach envelope
feeder
Reattach
Bins x–y
Description/action
Occurs when a source is loaded with an incorrect print media size as
specified in the Paper Menu.
Touch Continue. Load the specified source that is set for the requested
size.
Touch Automatically select media to override manual requests for Manual
Paper and Manual Env for the rest of the print job. All requests for
additional pages are automatically overridden, and print media is selected
from an automatic source.
Touch Cancel Job to cancel the current job if needed.
Touch Reset Active Bin to change to another linked bin.
Occurs when the MFP requests that a specific media source be loaded with
a specific type and size as specified in the Paper Menu, but the current
source contains an incorrect media size and type.
Touch Continue. Load the specified source that is set for the requested size
and type.
Touch Cancel Job to cancel the current job if needed.
Touch Reset Active Bin to change to another linked bin.
The MFP detects that the optional envelope feeder is missing between the
time the job processes, and when it prints. Sometime during processing, the
optional envelope feeder is removed.
Touch Cancel Job to clear the message and continue without using the
optional envelope feeder.
Install the optional envelope feeder.
Bins x–y=Bins 1 to 5, Bins 2 to 6, or Bins 6 to 10
This messages displays for the following conditions:
• The specified output bins may have been removed from the printer,
possibly to clear a paper jam or to remove the option.
• The option(s) may be attached to the printer but a communications
problem may prevent the printer from detecting the option. For example,
there may be a poor connection or a hardware failure.
The following actions may be taken:
• If the option was temporarily removed or not connected properly,
reattach or reconnect it.
• Accept the configuration change which notifies the printer the option has
been hot unplugged (removed with the power on).
Note: This action is not available if the printer is in Diagnostics Mode or
running diagnostics.
• If the device is experiencing a hardware problem, turn the printer off and
on. If the message continues to be displayed, go to
service check" on page
"Input tray(s)
2-147.
Diagnostic information
7002-xxx
2-47