Lexmark X642e Service Manual page 82

7002-xxx
User attendance messages (continued)
Sub
Code Primary message
code
Clean scanner
glass
Disk corrupted
Disk Full – Scan
Job Canceled
Insert Cartridge
or Close Door
Insert tray [x]
Install Bin x
or Cancel Job
2-44
Service Manual
Description/action
During a scanner calibration, the firmware detects that the scanner ADF or
flatbed glass may be dirty.
Touch Cancel Job if a scan job is processing when the attendance
message appears. This cancels the job and clears the message.
Touch Scan from Automatic Document Feeder if the page jam recovery is
active. Scanning resumes from the ADF immediately after the last
successfully scanned page.
Touch Scan from flatbed if page jam recovery is active. Scanning resumes
from the flatbed immediately after the last successfully scanned page.
Touch Finish job without further scanning if page jam recovery is active.
The job ends at the last successfully scanned page, but the job is not
canceled. Successfully scanned pages go to their destination: copy, fax, e-
mail, or FTP.
Touch Restart job if job recovery is active and the job can be restarted. The
message clears. A new scan job containing the same parameters as the
previous job starts.
Model X646e only. Occurs when the MFP attempts a hard disk recovery on
a corrupted hard disk, and the hard disk cannot be repaired. The hard disk
must be reformatted.
Touch Reformat disk to reformat the hard disk and clear the message.
Warning: All files stored on the hard disk are deleted.
Model X646e only. The scan job cancels or stops due to insufficient hard
disk space.
Note: The scanner finishes scanning currently committed pages in the ADF,
but data is lost when the job cancels itself.
Touch Continue to clear the message.
This message displays when the printer front door is open or the print
cartridge is missing.
If this message cannot be cleared, go to
service check—printer" on page
Occurs when the MFP detects a missing tray. x can be 1, 2, 3, 4, or 5.
Insert the specified tray to clear the message.
Touch Cancel Job to cancel the current job if needed.
Touch Reset Active Bin to change to another linked bin.
If the message cannot be cleared, go to
check" on page 2-158 or
Bin x=Bin 1, Bin 2, or Bin 3.
This message is displayed when a paper handling option has been hot
unplugged. The printer requires the reinstallation of the option to print a
page which has been formatted by the interpreter before the option was
removed.
The following actions may be taken:
• Install the option.
• Select one of the following:
- Cancel Job
- Reset Printer
- Reset Active Bin
If the message cannot be cleared, go to
page 2-147.
"Cover closed switch/cable
2-125.
"Paper size sensing service
"Input tray(s) service check" on page
"Input tray(s) service check" on
2-147.