Lexmark X642e Service Manual page 78

7002-xxx
User status displays (continued)
Sub
Display text
Code code
Ready
Scanner automatic
document feeder
cover open
Standard Bin Ful
Bin [x] Full
[bin name] Full
System busy,
preparing
resources for job.
System busy,
preparing
resources for job.
Deleting held
job(s).
Toner Low
Tray [x] Empty
Tray [x] Low
Tray [x] Missing
Waiting
Fax status displays
2-40
Service Manual
Description/action
The MFP is ready to receive and process jobs.
Print, fax, scan, e-mail, copy, or use FTP.
The automatic document feeder (ADF) cover is open.
Close the cover.
The standard bin is full.
x represents the number of the bin that is full.
[bin name] specifies a previously defined name for the bin, such as Mary's
bin, and it is full.
Remove the stack of print media from the standard output bin or from the
specified bin to clear the message.
Not all resources needed for the job are available.
Wait for the message to clear.
Not all resources needed for the job are available. Some held jobs are
deleted to free system memory.
Wait for the message to clear.
The toner cartridge is low on toner.
The Menu Settings Page shows the level. It takes an unspecified amount of
time for the MFP to read the level of toner. Until the level is read, the MFP
does not show the message.
• The message clears automatically when the cover or door over the toner
cartridge is opened or if the MFP power is turned off and then on.
• Replace the toner cartridge. If it is not replaced, the MFP issues the
message again when the door or cover is closed.
x represents the number of the tray. The tray has no print media installed.
1. Remove the tray. The message clears.
2. Install print media in the tray according to the User's Guide.
3. Insert the tray.
x specifies the number of the tray that is low.
Load print media into the specified tray to clear the message.
x represents the number of the tray missing from the MFP.
The message is on the Menu Settings Page also.
Insert the tray to clear the message.
If the Tray 1 Missing message does not clear when tray 1 is inserted, go to
"Parallel port service check" on page
message does not clear by inserting the tray, go to
check" on page 2-147.
The MFP receives a page of data to print but waits for an End of Job
command, a Form Feed command, or additional data.
Press Stop. Touch Continue to print the contents of the buffer.
Cancel the current job.
Wait for the message to clear.
2-159. If Tray 2 through 5 Missing
"Input tray(s) service