925.Xx-Hot Fuser Service Check - Lexmark X642e Service Manual

925.xx—Hot fuser service check
Error Code 923.xx, 924.xx, and 925.xx may display for a hot fuser failure.
CAUTION
The fuser may be hot, use caution before removing or servicing.
CAUTION
There is a danger from hazardous voltage in the area of the product where you are working.
Unplug the product before you begin, or use caution if the product must receive power in order
to perform the task.
Service tip: Set the Fuser Temperature to NORMAL before starting this service check. In Diagnostics mode, In
Diagnostics mode, select EP SETUP, and Fuser Temp.
FRU
1 Fuser lamp
2 AC power source
3 Fuser lamp
Action
If the fuser is 220 V machine a 115 V fuser may be installed.
If the printer is not a 115 V model, then go to step 2.
If the printer is a 220 V model, then check to make sure that the
correct lamp is installed.
Note: If the fuser lamp is replaced, allow the fuser to cool or a 925.xx
error could be displayed.
Check the AC power source to make sure it meets specifications. If
the AC power source does not meet specifications, inform the
customer. If it meets specifications, go to step 3.
Turn the printer off and allow the fuser assembly to cool. After the
fuser assembly cools down, turn the printer on. If you receive the
same error code, replace the fuser lamp. See
on page 4-86.
Note: If the fuser lamp is replaced, allow the fuser to cool or a 925.xx
error could be displayed.
7002-xxx
"Fuser lamp removal"
2-137
Diagnostic information