Flash Test; Printer Setup; Defaults - Lexmark X642e Service Manual

Flash Test

This test verifies the functioning of the flash device by writing and reading data on the flash to test the flash.
Warning: This test destroys all data on the flash because the flash is unformatted at the end of the test. To
reformat the flash, the servicer or the user must use FORMAT FLASH from the UTILITIES MENU.
To run the Flash Test:
1.
Touch
The message Contents will be lost. Continue? displays to warn the user that all contents on
the flash device will be lost.
2.
To exit the test immediately and return to the Device Tests menu, touch No. To continue, touch Yes.
The power indicator blinks while the test is running, and the message Flash Test Testing... displays.
Once the test is complete, the power indicator turns on solid, and either the message Flash Test Test
Passed or Flash Test Test Failed displays.
3.
Touch Back or press Stop (

PRINTER SETUP

PRINTER SETUP

Defaults

Printed Page Count
Permanent Page Count
Serial Number
Envelope Enhance
Engine Setting 1
Submit
The triangles pointing up or down indicate whether there are additional menus. Touch the up or down arrows to
display these additional menus.
Note: If you make changes, touch Submit to make the change effective.
Defaults
US/Non-US defaults changes whether the printer uses the US factory defaults or the non-US factory defaults.
The settings affected include paper size, envelope size, PCL symbol set, code pages, and units of measure.
Warning: Changing this setting resets the printer to factory defaults, and data may be lost. It cannot be undone.
to select Flash Test from DEVICE TESTS.
)
to return to DEVICE TESTS.
Models X644e/X646e
US
127
127
xxxxxxx
Medium
0
Back
Model X642e
PRINTER SETUP
Defaults
U.S.
Printed Page Count
127
Perm Page Count
127
Serial Number
xxxxxxx
Submit
7002-xxx
Back
3-17
Diagnostic aids