7002-xxx
Removal procedures
CAUTION
Remove the power cord from the MFP or wall outlet before you connect or disconnect any
cable or electronic board or assembly for personal safety and to prevent damage to the MFP.
CAUTION
Use the handholds on the side of the MFP. Make sure your fingers are not under the MFP when
you lift or set the MFP down.
Note: Some removal procedures require removing cable ties. You must replace cable ties during reassembly to
avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
Scanner ADF and flatbed removals
ADF front cover removal
1.
Open the ADF top cover.
2.
Remove the two screws (A).
3.
Release the ADF front cover latch (B) on the right side under the scanner, and then release the latch (B) on
the left side.
4-6
Service Manual
A