Lexmark X642e Service Manual page 126

7002-xxx
User attendance messages—paper jams and paper handling errors (2xx.xx)
Sub
Code Description
code
243 .10 Fail to feed from tray 3
243 .13 Paper over tray 3 pass
thru sensor on warm-up.
243 .15 Late feed from a tray
interfered with the pick
retry.
243 .16 Failed to feed from tray
3. Pages in the paper
path have been flushed
to the output bin.
243 .17 One or more trays
located above the
source tray have been
removed.
244 .00 Paper jam near tray 4.
244 .02 Jam declared by a smart
device. Immediate stop.
244 .03 Jam declared by a smart
device. Homing allowed
to stop.
244 .04 Option tray pass thru
sensor never became
covered.
2-88
Service Manual
Possible causes
Failure to feed. Possible causes include:
• Edge locking
• Worn or contaminated pick tires
• Overfilling of tray past fill line
• Failed sensor
• Paper left in path
• Failed pass thru sensor
Failure to feed. Possible causes include:
• Edge locking
• Worn or contaminated pick tires
• Overfilling of tray past fill line
• Failed pass thru sensor
• Tray removed
• Sensors faulty
• Tray removed
• Sensors faulty
Fault reported by options tray 4:
• Paper jam
• Motor or motor cable failure
• Sensor failure
Fault reported by options tray 4:
• Paper jam
• Motor failure
• Sensor failure
Failure to feed. Possible causes include:
• Edge locking
• Worn or contaminated pick tires
• Overfilling of tray past fill line
• Failed sensor
If source is tray 5, possible causes
include:
• Paper path bind when feeding from
tray 2 through tray 1
• Damaged PTO shaft.
Action
• Clear media jams.
• Replace pick tires. See
"Integrated tray
autocompensator pick roll
assembly removal" on
page 4-105.
• Check/replace input sensor.
• Clear media jams.
• Check/replace pass thru
sensor.
• Clear media jams.
• Replace pick tires. See
"Integrated tray
autocompensator pick roll
assembly removal" on
page 4-105.
• Check/replace input sensor.
• Reinstall tray.
• Check sensors.
• Clear media jams.
• Check sensor.
• Clear all media jams.
• Check motor cables.
• Check/replace tray motor.
• Check/replace sensor(s).
• Replace entire option.
• Clear all media jams.
• Check motor cables.
• Check/replace tray motor.
• Check/replace sensor(s).
• Replace entire option.
• Clear media jams.
• Replace pick tires. See
"Integrated tray
autocompensator pick roll
assembly removal" on
page 4-105.
• Check/replace input sensor.
• Check PTO shaft.