Lexmark X642e Service Manual page 100

7002-xxx
User attendance messages—paper jams and paper handling errors (2xx.xx)
Sub
Code Description
code
201 .24 Expected wide page not
detected by narrow
media sensor, possible
accordion jam. Fuser
page count between
200,000 and 299,999
201 .30 Page did not reach exit
sensor. Fuser page
count between 300,000
and 399,999
201 .31 Main drive motor
identification failed.
Fuser page count
between 300,000 and
399,999.
201 .32 Page did not reach exit
sensor. Fuser page
count between 300,000
and 399,999.
201 .33 Video never started with
page two inches past
the input sensor. Fuser
page count betwee
300,000 and 399,999.
2-62
Service Manual
Possible causes
• Page did not enter or exit fuser nip
cleanly.
• Narrow media sensor not functioning
correctly.
• Actual page is narrow when wide
page was expected.
• Page jammed on fuser input guide.
• Page did not enter or exit fuser nip
cleanly.
• Exit sensor not functioning correctly.
Main drive motor not working.
• Page jammed on fuser input guide.
• Page did not enter or exit fuser nip
cleanly.
• Exit sensor not functioning correctly.
Action
• If label media, ensure front
edge meets 1/8 inch
requirement.
• Check fuser for wear or
contamination. If problem is
found, replace the fuser
assembly. See "Fuser
assembly removal" on
page 4-79.
• If media is narrow, then turn
off first sheet detection (In
Diagnostics Menu,
PRINTER SETUP, Engine
Settings 3. Select 16 and
touch Submit).
• The fuser narrow media
sensor may not be
functioning properly. Go to
"Fuser narrow media
sensor service check" on
page 2-139.
• Check the fuser entry guide
for toner build up.
• Check fuser for wear or
contamination. If a problem
is found, replace the fuser
assembly. See "Fuser
assembly removal" on
page 4-79.
• The fuser exit sensor may
not be functioning properly.
Go to "Fuser exit sensor
service check" on
page 2-138.
Check the motor connections to
motor and system board. If no
problem is found, go to "Main
drive service check" on
page 2-153.
• Check the fuser entry guide
for toner build up.
• Check the fuser for wear or
contamination. If a problem
is found, replace the fuser
assembly. See "Fuser
assembly removal" on
page 4-79.
• The fuser exit sensor may
not be functioning properly.
Go to "Fuser exit sensor
service check" on
page 2-138.