Fuser Solenoid Service Check - Lexmark X642e Service Manual

7002-xxx

Fuser solenoid service check

CAUTION
There is a danger from hazardous voltage in the area of the product where you are working.
Unplug the product before you begin, or use caution if the product must receive power in order
to perform the task.
Service tip: Try changing the envelope enhance level setting. A different setting may correct the problem.
Note: Check the fuser envelope conditioner solenoid adjustment as described in the adjustment section
solenoid adjustment" on page
FRU
1 Fuser envelope conditioner
solenoid
2 System board
3 LVPS
4 Fuser board to system
board cable
5 Fuser assembly
2-140
Service Manual
4-2.
Action
Observe the operation of the fuser solenoid by removing the redrive
assembly. Check for proper mechanical operation of the solenoid and
associated hardware, link, and so on. If correct, check the resistance
of the solenoid between J4-1 and J4-2 on the fuser control board.
The resistance measures between 5 ohms and 10 ohms. If incorrect,
replace the fuser assembly. If correct, go to step 2.
Measure the voltage at the +50 V dc test point on the system board.
The voltage should measure approximately +50 V dc. If incorrect, go
to step 3. If incorrect, go to step 4.
Measure the voltage at CN2-18 on the LVPS. The voltage should
measure approximately +50 V dc. If incorrect, replace the LVPS
assembly. See "Low voltage power supply removal" on
page 4-109. If correct, replace the system board. See
board and inner shield removal—model X642e" on page 4-130
"System board and inner shield removal —models X644e/
X646e" on page 4-131.
Make sure the cable is connected properly to the system board and
fuser control board. Reconnect the cable, if necessary. If the cable is
connected correctly, go to step 5.
If no problems were found in steps 1 through 4, replace the fuser
assembly. See "Fuser assembly removal" on page
"Fuser
"System
or
4-79.