Flatbed Size Sensor Service Check - Lexmark X642e Service Manual

Hide thumbs Also See for X642e:
Table of Contents

Advertisement

260.xx Paper Jam displays, envelope stops in feeder paper path
FRU
1
Kick rolls/feed rolls/drive
rolls
2
Deflector gap adjustment
Envelope feeder multifeeds or may not display a
FRU
1
Envelopes
2
Deflector
3
Restraint roll bias spring
260.xx Paper Jam displays, an envelope stopped in the paper path of the feeder
and an envelope also stopped in the printer paper path
FRU
1
Latch lever

Flatbed size sensor service check

Check for correct installation of the sensor cable before proceeding with this service check.
Note: All three sensors and their cables come attached together as a unit.
FRU
1
Flatbed paper size sensor
assembly
Flatbed interface card
assembly
Action
Check all the rolls for oil, grease, or other contamination. If you find a
problem, clean the rolls. If this does not correct the problem, replace
the envelope feeder.
Check the deflector gap adjustment. The adjustment may be too
narrow. If the adjustment is correct, replace the envelope feeder
option.
260.xx Paper Jam
Action
Check the envelopes being used in the feeder. Check for signs of the
envelopes being stuck together or signs of glue. Make sure the flaps
are not interleaved.
If the envelopes meet the guidelines and are properly loaded, go to
step 2.
Check the deflector gap adjustment. The adjustment may be too
wide.
If the deflector gap adjustment is correct, go to step 3. If not, replace
the envelope feeder option.
Check for a missing, broken or incorrectly installed restraint roll bias
spring. If incorrect, replace the envelope feeder option.
Action
Make sure the tip of the latch lever is centered in the opening in the
floor of the paper path. The latch lever may not be detented on the
latch. If no problem is found and the problem persists, replace the
envelope feeder option.
Action
Enter the Diagnostics Menu (turn on MFP while holding 3 and 6),
select SCANNER TESTS, and select Sensor Tests. Check for
correct operation of the sensors by placing a piece of paper on the
contact glass over the sensor assembly. If any sensor fails the sensor
test, replace the sensor assembly. If this does not fix the problem,
replace the flatbed interface card. See
removal" on page
4-33.
7002-xxx
message
"Flatbed interconnect card
2-131
Diagnostic information

Advertisement

Table of Contents
loading

This manual is also suitable for:

X644eX646e

Table of Contents