Lexmark X642e Service Manual page 122

7002-xxx
User attendance messages—paper jams and paper handling errors (2xx.xx)
Sub
Code Description
code
239 .03 Duplex did not send
Device Controls
response.
239 .04 Duplex did not send
Input Device Ready
response.
239 .05 Duplex did not send
Page In Output Device
response.
239 .06 Failed the last page of a
staple job.
239 .07 Engine never sent
Select OUtput Device to
the duplex unit because
the page leaving the
duplex never sent Select
Input Device.
239 .08 Engine never saw Input
Source Read on a page
to be picked from the
duplex unit that is
waiting on a page to
pass the input sensor.
239 .11 Sheet picked from
duplex never made it to
the input sensor. Slow or
delayed feed from the
duplex unit.
241 .00 Paper jam near tray 1
241 .04 Not applicable to tray 1
241 .05 Not applicable to tray 1
241 .06 Failed to pick from tray 1
241 .07 DC feed
autocompensator stalled
on a pick
241 .08 Received lots of dc feed
interrupts before losing
them.
2-84
Service Manual
Possible causes
• Mechanical feed error due to belt
slipping.
• Timing error due to feed system.
• Mechanical feed error due to belt
slipping.
• Timing error due to feed system.
• Mechanical feed error due to belt
slipping.
• Timing error due to feed system.
• Mechanical feed error due to belt
slipping.
• Timing error due to feed system.
• Mechanical feed error due to belt
slipping.
• Timing error due to feed system.
• Mechanical feed error due to belt
slipping.
• Timing error due to feed system.
• Mechanical feed error due to belt
slipping.
• Timing error due to feed system.
• Input sensor not working correctly.
Paper jam around autocompensator,
faulty motor cable, faulty motor,
autocompensator gear bind, failed
controller card.
Paper jam around autocompensator,
faulty motor cable, faulty motor,
autocompensator gear bind, or failed
controller card.
Paper jam around autocompensator,
faulty motor cable, faulty motor,
autocompensator gear bind, or failed
controller card.
Action
Replace the duplex option.
Replace the duplex option.
Replace the duplex option.
Replace duplex option.
Replace the duplex option.
Replace the duplex option.
Check duplex sensor cables for
correct installation. If no
problem is found with the
cables, replace the duplex
option.
• Check for jam in tray.
• Check for overloaded tray.
• Check pick assembly and
controller card.
• Check for jam in tray.
• Check pick assembly and
controller card.
• Check for jam in tray.
• Check pick assembly and
controller card.