Package Contents; Radio And Antennas; Reset Button - HP 525 Quick Start Manual

Package contents

The AP, mounting hardware, MAC address label, and documentation.
Ports
The AP provides the following ports:
Two auto-sensing 10/100/1000 BASE-T Ethernet port with an RJ-45
•
connector—Ethernet port 1 that supports PoE and Ethernet port 2.
Standard console (serial) port with an RJ-45 connector.
•
Two 2.4 GHz antenna ports and two 5 GHz antenna ports.
•
48 VDC power port.
•
Caution: Never connect the console port to an Ethernet switch or PoE power
source. This can damage the AP. You can connect the console port only to a
serial port by using an RJ-45 connector or to a serial port adapter.

Radio and antennas

The AP supports two radios: 802.1 1a/n/ac on Radio 1 and 802.1 1b/g/n on
Radio 2 with 2x2 MIMO two spatial stream.
The AP contains four internal dual-band, MIMO antennas. It also provides two
antenna ports for each radio.

Reset button

The reset button is on the front panel of the AP. To reset the AP, press the button
for 0 to five seconds. To restore the AP to the factory setting, press the button
for more than five seconds and less than fifteen seconds.
2