Package Contents; Radio And Antennas; Reset Button - HP 527 Quick Start Manual

Package contents

The HP 527, mounting bracket, screws, MAC address label, and documentation.
Ports
x x
Three Gigabit Ethernet ports: Auto-sensing 1000Base-T Ethernet ports with RJ-45
connectors.
x
One Gigabit Ethernet uplink port: Auto-sensing 1000Base-T Ethernet port with RJ-
45 connector.
x
One pair of pass-through ports: Work with Cat5 cabling as well as an analog
telephone cable.

Radio and antennas

The HP 527 supports IEEE 802.1 1a/b/g/n/ac. It has two internal antennas
supporting 2x2 MIMO with two spatial streams at a rate of up to 850 Mbps.

Reset button

The reset button is accessible through a hole on the side panel of the HP 527. To reset
the HP 527, insert a paper clip into the reset button hole, and press and quickly
release the button. To reset the HP 527 to factory defaults, press and hold the button
more than 5 seconds until the status LEDs (Power, Radio, and Uplink) flash, then
release.
Status LEDs
Status LEDs power
Radio
Uplink
LAN ports 1, 2, and 3
PoE Out
2